I have an Intermatic generic binary zwave duplex wall outlet installed in a second home 1,000 miles away. I just realized that, if I turn it off, the switch seems turns itself on 10 minutes later...over and over and over.
A rescan gives a warning that the switch is not associated with the zstick; but the association option is greyed out on the device tab. I find that the switch manually turns on and off fine and has excellent connections with about 25 other devices. However, if I try to optimize it, it fails saying that it cannot communicate with the zstick.
I noticed that the polling interval was 10 minutes. On a hunch, I changed it to 15 minutes and, sure enough, it turned itself on in 15 minutes. Then I tried a manual poll of the device from my homepage and, again, it turned the switch on. Any guidance on ways to repair?
A rescan gives a warning that the switch is not associated with the zstick; but the association option is greyed out on the device tab. I find that the switch manually turns on and off fine and has excellent connections with about 25 other devices. However, if I try to optimize it, it fails saying that it cannot communicate with the zstick.
I noticed that the polling interval was 10 minutes. On a hunch, I changed it to 15 minutes and, sure enough, it turned itself on in 15 minutes. Then I tried a manual poll of the device from my homepage and, again, it turned the switch on. Any guidance on ways to repair?